713-270-8520
View Product Reviews
|
226156-SCAA - Deyeme Adjustable Short Shifter Arm, Manual Transmission Dart/Renegade/Cherokee/500L/Compass |
< Return to product |
|
Product Rating: 
Date Posted: 2022-05-04 17:58:26
|
| Awesome Product |
| Posted By: Brandon |
| Location: Reno, NV United States |
|
Comments: Installed in my dart and the reduction of throw is great with the stock shifter |
Product Rating:
Date Posted: 2020-10-19 10:35:13
|
| Improvement over stock |
| Posted By: Jarad Huxoll |
| Location: Williston , ND United States |
|
Comments: Installed on my Fiat 500X. Works wonderfully. Had issue with stock rod hitting shift linkage on top of transmission on shortest throw causing a lack of second gear. Moved to middle hole for now until my improved shift rod shows up. |
|
Product Rating:
Date Posted: 2020-04-12 10:16:09
|
| Deyeme Adjustable Shift Control Arm |
| Posted By: Bruce Nguyen |
| Location: lilburn, GA United States |
|
Comments: Great product, this shorten the shifter throw a lot more than the MPx short shifter. But the website should mention that the control arm only work with Deyeme Shift Rod, the stock one does not work with sport or race position. I would rate 5 stars if the website mention that, now I have to order the shift rod and install it again. |
|
Product Rating:
Date Posted: 2020-01-19 20:42:43
|
| Easy install adjustable short shift arm |
| Posted By: Ryan W Vallieu |
| Location: Los Altos Hills, CA United States |
|
Comments: I combined this adjustable short shift arm with the Deyeme shift link strut. I did this shirt shift arm install because I had installed a new shift knob with an adapter that raised the height of the shifter by an inch. This lengthened the throw a little. This arm set to the middle position is awesome with the taller shifter. Install was Uber easy! Once you get the oem link arm to pop off, it's just one nut holding it in place. I used a plastic trim remover that had a wedge shape and tapped it with a small hammer to get the oem arm to pop off. I took the battery and battery tray out and had ample room. I used blue loctite on the ball screw threads, as I was worried about it coming loose. No issues this far. The new nut that holds the arm in place was easy to install. I really like the short shift with the link strut and the new shift ball with the extra height. It all works together perfectly. |
|
Product Rating:
Date Posted: 2019-07-09 06:28:48
|
| good idea |
| Posted By: Kyle Veit |
| Location: Boise, ID United States |
|
Comments: intake must be removed to reach the area to install. one time use hose clamps are no fun. .the instructions tell you to "practice a few times" before trying to put the arm on and insert the pin. it takes a great deal of patience and steady hands to get it hooked up. kinda worth it, maybe compares to original oem but mine was quite worn down. |